WIRELESS 4-20MA CURRENT LOOP SENSOR / BRIDGE
Overview
The 4-20mA sensor uses a 10-bit ADC to measure an analog value between 4 and 20mA with a 10uA resolution. If the measured value rises above or falls below the configured thresholds, an alert is sent over the wireless network. The Armored Sensor™ IP67 weather-proof enclosure makes the sensor suitable for outdoor and industrial use.
The 4-20mA sensor can also be used as a bridge device to enable a wide variety of sensors with only a 4-20mA output. See the article Using Radio Bridge’s 4-20mA Current Loop Sensor to Connect Off-the-Shelf Devices to LoRaWAN for more information.
Features
- Based on LoRaWAN wireless technology
- Very long range up to several miles
- Excellent wireless penetration through structures such as walls and floors
- Enclosure tamper detection
- Automatic error reporting through supervisory messages
- Over the air configuration
Applications
- Monitoring industrial process control outputs
- Monitor signaling to control valves
- General monitoring of a 4-20mA industrial output
MAXBOTIX ULTRASONIC TO LORAWAN BRIDGE
Overview
The Maxbotix ultrasonic sensor to LoRaWAN bridge provides LoRaWAN connectivity for any HR series sensor with TTL output (RBS306-MBHR) or any XL series sensor with RS-232 output (RBS306-MBXL):
When ordering an Ultrasonic sensor from Maxbotix, be sure to include the Radio Bridge connector MB7985 to ensure it connects seamlessly into the wireless bridge.
Features
- Based on LoRaWAN wireless technology
- Very long range up to several miles
- Excellent wireless penetration through structures such as walls and floors
- Enclosure tamper detection
- Automatic error reporting through supervisory messages
- Over the air configuration
Applications
- Tank level monitoring and measurements
- Factory bin level detection
- Waste management and garbage levels
- Smart parking systems
- Snow level monitoring
- Rangefinder distance measurement
WIRELESS IP67 DRY CONTACT SENSOR / BRIDGE
Overview
The two-wire dry contact sensor detects a connection between two wires. The Armored Sensor™ IP67 weather-proof enclosure makes the sensor suitable for outdoor and industrial use. An indoor/smart building version is also available for low-cost applications.
The contact sensor can be used as a bridge device to enable a wide variety of sensors. See the article connect third party sensors to LoRaWAN with a dry contact bridge for more information.
Features
- Based on LoRaWAN wireless technology
- Very long range up to several miles
- Excellent wireless penetration through structures such as walls and floors
- Enclosure tamper detection
- Automatic error reporting through supervisory messages
- Over the air configuration
Applications
- Doorbell press detection
- Remote button press detection
- Remote reed switch detection
- General-purpose contact sensor (two-wire open/close detection)
WIRELESS DRY CONTACT SENSOR / BRIDGE
Overview
The two-wire dry contact sensor detects a connection between two wires. An Armored Sensor™ IP67 weather-proof version is also available for outdoor and industrial use.
The contact sensor can be used as a bridge device to enable a wide variety of sensors. See the article connect third party sensors to LoRaWAN with a dry contact bridge for more information.
Features
- Based on LoRaWAN wireless technology
- Very long range up to several miles
- Excellent wireless penetration through structures such as walls and floors
- Enclosure tamper detection
- Automatic error reporting through supervisory messages
- Over the air configuration
Applications
- Doorbell press detection
- Remote button press detection
- Remote reed switch detection
- General-purpose contact sensor (two-wire open/close detection)